K-1000S Programmable LED Controller with SD Card 2048 Pixel Manual Switch LED strip Light Controller
1. 32 level -65536 grayscale control, software Gamma correction processing.
2. support various points, lines, surface light source, support various rules, special-shaped processing.
3. the controller can take 2048 pixels.
4. compatible with single and double line IC, single line IC lamps, no need to connect CLK clock line.
5. The data line DAT of the luminaire, the CLK of the clock line and the GND of the negative electrode.
Notes:
1. When the controller port is loaded with 512 lights, the playback speed can reach 30 frames per second, and when the port is loaded with more than 512/1024 lights, the frame frequency automatically decreases with the increase of the number of lights.
2. For the output of TTL signal, the controller must supply the ground with the lamp (that is, connect the output of the control ground wire with the ground wire of the lamp).
By default, the signal generated by the controller is TTL signal.
SET Save Settings (if you press SET key, the current settings file and playback speed are saved, the next boot after throwing this playback)
MODE Toggle File
SPEED+ Speed Up
SPEED- Slows Down
Press SPEED+ and SPEED- at the same time, then enter the file loop mode.
Product Description
Denetlenen Tedarikçi 
