DIN Ray Anahtarlama Güç Kaynağı

Characteiristics:

Universal range voltage input, double insulation level, high safety, low non-load standby consumption and standard rail installament.

Features:
Universal AC input/ full range
Protections: Short circuit/ Over load/ Over voltage
Cooling by free air convection
Can be installed on DIN rail TS-35/7.5 or 15
Solation classII
LED indicator for power on
100% full load burn-in test
1 years warranty
Dimensions: 78*93*56mm (W*H*D)

Introduction:
OUTPUT
1. DC voltage: 5V, 12, 15V, 24V, 48V
2. Rated Current: 6.5A, 4.5A, 4A, 2.5A, 1.3A
3. Rated Power: 32.5W, 54W, 60W, 60W, 62.4W
4. Ripple & Noise: 80MVP-p, 120MVP-p, 120MVP-p, 150MVP-p, 150MVP-p
5. Setup, Rise Time: 100ms, 30ms/230VAC at full load200ms, 30ms/115VAC at full load
6. Hold Time: 100ms/230VAC23ms/115VAC at full load

INPUT
1. Voltage Range: 88~264 VAC47~63 Hz; Selected by switch 124~370VDC
2. AC Current: 1.2A/115 V 0.8A/ 230 V
3. Efficiency: 76%, 82%, 83%, 84%, 85%
4. Inrush Current: Cold start 20A/115V 40A/230V
5. Leakage Current: <1mA/240VAC

PROTECTIOIN
1. OverLoad: 105%~160%
Protection type: Hiccup mode, recovers automatically after fault condition is removed
2. Over Voltage: 115%~135%
Protection type: Hiccup mode, recovers automatically after fault condition is removed

ENVIRONMENT
1. Working Temp., Humidity: -20 ~ +60; 20%~90 %RH
2. Storage Temp., Humidity: -40~ +85; 10%~95 %RH
3. Vibration: 10~500Hz, 2G 10min. /1cycle, period for 60min, each along X, Y, Z axes

SAFETY
1. Withstand Voltage: I/P-O/P: 3KVAC
2. Isolation Resistance: I/P-O/P: 100M Ohms / 500VDC

STANDARD
1. Safety Standard: Design refer to UL60950-1, TUV EN60950-1, EN50178
2. EMC Standard: Design refer to EN55011, EN55022, EN61000-3-2, -3, EN61000-4-2, 3, 4, 5, 6, 8, 11, ENV50204,
EN55024, EN61000-6-2, EN61204-3

OTHERS:
1. Weight 0.26Kg
2. Packing: 45PCS/13Kg/1.22CUFT

NOTE
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12 twisted pair-wire terminated with a 0.1μ & 47μparallel capacitor.
3. Tolerance: Includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.