Hengfeng Waterproof Beautiful Epoxy Resin AB Adhesive for Orginal Crafts Flowers Making
| Item (HF1005) |
Epoxy Resin(A ) |
Epoxy Hardener (B ) |
| Color |
Transparent Liquid |
Transparent Liquid |
| Viscosity@25ºC(mpa.s) |
240 CPS |
100 MAXCPS |
| Specific Gravity |
1.12 |
1.06 |
| Mix Ratio(by weight) |
3 |
1 |
| Hardness(Shored) |
78 D |
| Operation time(100g mixed glue ,25ºC) |
45 Minutes(100g) |
| Curing Time(25ºC) |
4-5 Hours |
| Shelf Life |
12 Months |
Feature
Epoxy resin HF1005 can be cured under normal temperature and high temperature with long operation time and fast curing. With the feature of very low viscosity, good flowing property and can be natural defoamed, super yellow resistance, high transparency, no ripple, bright in surface, it is a ultra clear crystal epoxy with wide range of applications.
* Super Low Viscosity
* Bubbel free
* Easy to use
*Clear as water
*Anti-yellow for at least five years
*Food grade FDA approved resin
Wooden furniture, top coating, craft casting, epoxy floor, soft doming resin, etc...
Customize specification can be availabe for you, please contact with us
Free samples are available! Please contact us for more details and tell us what you need!
Free samples are available! Please contact us for more details and tell us what you need!
How to use
Step 1: The ideal working temperature is around a constant 77°F. Best results can be obtained at constant temperatures between 70°F and 85°F, in a clean, dry, dust-free environment. Avoid working in high humidity. We recommend using this product on a leveled and flat work surface.
Step 2: Measure product in accordance with your intended use. Prepare 2 parts Base Resin to 1 part Curing Agent by liquid volume.Pour the Curing Agent first and then the Base Resin into a clean, smooth-sided container large enough to hold all the liquid and allow room for mixing.
Step 3: The material must be mixed thoroughly for at least 3 minutes. Be sure to scrape the container sides, bottom, and corners as you mix. Be careful not to whip excessive air into the mixture. If mixing a gallon, use a power mixer set to "hand speed." For smaller quantities, use stir sticks. Do not mix more than a gallon. Pour into a new, clean container and mix for an additional minute.
Step 4: Pour the mixed resin onto the surface and distribute evenly with a squeegee or gloved hand. Continue to pour remaining material to achieve the desired thickness, allowing the resin to flow evenly over the project's sides. Resin can be poured up to 1/4" thick per pour.
Step 5: Use a heat source such as a heat gun to remove any bubbles by adding a small amount of heat to the surrounding area. The bubble will rise to the surface and pop.
Step 6: If you are going to make a second pour, the first pour should still be slightly sticky. Once the second pour is made, bubbles may once again need to be removed. Material will feel hard after 45-60 minutes, cure to the point of workability within 24 hours, but full cure and maximum hardness can require up to 7 days, depending upon the temperature.
Free samples are available! Please contact us for more details and tell us what you need!
Denetlenen Tedarikçi 
