Mobil kumlama Makinesi (HXP-X)

I. Purpose and Characteristics
HXP-X (cyclone) recycled suction-shot blasting machine has no dust pollution during the blasting operations, protecting the health of workers to be in line with national environmental requirements. It is mobile and flexible, widely used in machinery, ships, bridges, railways, oil pipelines, boilers and port construction industries for superficial dust abatement, surficial hardening of steel structure; And the superficial carving of leather, clothing, glass, stone etc.; Reroute change construction of the traffic routes and decorative treatment of fountains.

II. Technical parameters

Working Pressure: 0.6-0.7 MPa, adjustable pressure
Abrasive Type: Emery, corundum, copper slag, plastic balls and so on
Surface Treatment Level: SA2.5-3
Consumption: 2-3m3 / min
Grit Size: 16 mesh to 100 mesh
Blasting Efficiency: 2 ~ 4m2/h
Power: 2.2kw
Dimensions: 1.22 × 0.6 × 1.55m
Volume (m3) SiC (kg) Emery (kg) Grit (kg) Quartz sand (kg) Because of differences in material density, loading capacity data is for reference only

0.08 133 156 356 136

III. Working principle

Source of pressurized air goes into the intake port, the air sprays from the spray gun after regulation, attracting abrasive material into the spray gun, forming a high-speed abrasive airflow to beat against the workpiece.
Vacuum suction pump forms the vacuum, sucking back the discharge of abrasive material flow. Abrasive material flow is separated in the cyclone for the first time, leaving available abrasive material; Dust flow entering into the dust tube for the second separating, dust is separated out, through filter pump the clean air is sucked into the vacuum pump before into the atmosphere.

IV. Procedure

Check the appearance of the machine that should be in good condition, and all parts should be connected securely, the filter is without damage. By adding the abrasive material into the sand can through the mesh with an amount not less than 40 kg, and then tighten the knob on the cyclone. The spray gun can also be used for sand suction.

Connected to the gas source, opening the valve, starting the vacuum pump, and you shall feel the gun is sucking a large number of inhale in the mouth. Adjusting the vacuum filtration pair to the appropriate working pressure.

Handing the spray gun, letting the brush head be close to the surface of the workpiece, pressing the switch on the gun, which has began blasting, regulating the valve to the best sand for blasting effect. During the work process, you must always keep the brush head flat against the workpiece surface with uniform movement, but not allowed to leave.

Depending on different surface roughness, replacing different types and sizes of abrasive material; Replacement brushes of different shapes for processing exterior angle and circular shapes such as artifacts.
The sand tubes, trachea and recovery pipe shall be straight and flat as possible with less bending, so as not to affect the results of the sand.

After finishing work, releasing the switch on the spray gun, do not immediately raising the gun to ensure abrasive spray is fully recycled. Finally, close the valve and disconnect the gas source.

The separation level between the abrasive material and dust can be adjusted, open cyclone, there is a block dust plate, by replacing dust plates of different sizes, the size of the separated dust particles can be adjusted. The larger dust plate is, the greater separated dust particles; The smaller dust board, the separated dust particles is smaller.